Lenze 8200 vector LECOM communication modul and GDC software

Please help me how to connect Lenze vector 8200 + Lecom communication modul+ computer to upload parameter from Lenze inverter 8200? I did try to do as follow:

Connect PC --> RS232---> Lecom 2102IB.V001--->Lenze 8200vector.
RS 232 connection : Lenze drive PC
9-pole SubD male plug 9-pole SubD female plug
PIN PIN
2 o-------------------------------o 3
3 o-------------------------------o 2
5 o-------------------------------o 5
Port setting:
Character
Format
7 bit ASCII
1Stopbit
1Startbit
1 Parity bit (even).
Baud rate: 9600.
Please let me know if any mistake.

Thanks
Hungcv

There are lots of manuals on the site of Lenze. I have no experience with Lecom, so I can't help you.

I am in need of the LECOM-A/B module. Where can i get one please?

Lenze lecom

you can contact the following e-mail for the quotation.

[email protected]
Contact person: Mr. Phước.
Remember CC me the mail if you send him your requiment

ok. thank you

But how do I cc you?
I don't have your email add.

I just sent him a mail though.

lenze LECOM

My e.mail: [email protected]
last time I had trouble with this but now overcome