Communication problem?
- Thread starter niyaz432
- Start date
niyaz432, no offense, but after reading your 4 posts until now, I can only recommend that you stay way from DCS systems.
If you are an end-customer, then get someone who knows about DCS to do the project for you.
If you are trying to sell a control system to a customer, then you are unqualified to do so by yourself. You could hire someone with the know-how to work for you or you company, maybe just for this one project.
If you are an end-customer, then get someone who knows about DCS to do the project for you.
If you are trying to sell a control system to a customer, then you are unqualified to do so by yourself. You could hire someone with the know-how to work for you or you company, maybe just for this one project.
hey guys..finally found out answer........actually my plc is supporting MODBUS MASTER PROTOCOL...i am using ML200-HONEYWELL PLC for BAG filter operation...and we done communication with ABB DCS by using..rs485 configuration ...i.e TX-RX, RX-TX, GND-GND. and also we checked through MODSCAN32 software....READ/WRITE bits STARTS WITH 40,001 onwards....
Similar Topics
I have an issue on my vessel, we have water tight door system created in China, company is no longer operating. We have 7 doors each with their...
Hello everyone,
One of our machine we use Siemens Cpu315-2dp. And this cpu communicate with 4 Lenze servo drives series 9300 via profibus. Also...
I have wasted a week trying to figure out how to connect an SLC5/03 with my laptop.
I do not have and can not Buy the 1747 UIC and PC3 cables.
I...
I am having PLC S7 200 smart model- ST 30 .
In which I am getting problem in modbus communication of PLC and VFD via built in RS 485 port of PLC...
Hi,
I have a Mitsubishi FX5U PLC where I cannot established communication via ethernet port of my computer. Search all videos and follow all the...