Omron Analogue Unit MAD01

Hello veryone

Could somebody assist me with trying to program my MAD01 analogue unit with a CPM2A controller.I have a W353-E1-1 programing manual which I followed and these where Iam.

I wire my input of 0-10V in the input one terminals and used a current output.I am using range code FF04 Which what I WIRED

I use the lader logic example that was given by the manual to write code and move inputs to the final outputs.

I think I am missing something which is to do with register or memory.

After tansfering and running I still could not get my output.
when I vary my 0-10volt input.

Your help will greatly appreciated

If you would ZIP your Omron program and post it here, someone may be able to help. If you can make a screen print of snapshot of the part that you have problems with, that would be a starting place.

I have manage to get it done but I have question in the maths section are you able to accumalte results and also reset it if so how.This is on the same omoron CPM2A type.