TSX and XBT => SIemens Panel ?
- Thread starter userxyz
- Start date
Its possible with 37/57 processors and older Protool/WinCC Flex hardware.
I think the driver has been dropped for WinCC V11.
Unfortunately its not a simple comm's cable setup - so You will need TSXSCA62 & TSXPACC01 boxes for protocol conversion.
It worked fine but in all honesty i wouldn't do it again - id just fit a Redlion G3 for the simplicity or Magelis etc.
I think the driver has been dropped for WinCC V11.
Unfortunately its not a simple comm's cable setup - so You will need TSXSCA62 & TSXPACC01 boxes for protocol conversion.
It worked fine but in all honesty i wouldn't do it again - id just fit a Redlion G3 for the simplicity or Magelis etc.
Last edited:
Similar Topics
Hello
I have a situation where a XBT-F HMI has lost its program. The program inthe TSX Micro PLC is fine. I have to create an HMI application to...
- Poll
Hi! Do you know about TSX4740 PLC? Is this model still existing/ supported by manufacturer? What hardware/software is required for upload/download...
After updating a panel, I inherited another PLC for my "learning lab". It's a Modicon TSX Micro. I've not worked with a Modicon PLC yet, so I...
Hello Dear Experts
I have to read 2 words (%MW300 / %MW301) in a M221 plc (TM221ME16R/G) which have a embedded ethernet port.
the reader plc...
My plc is stx micro 3722
My problem is err led is flashing
I tried to re programme my plc with pl7 programme
The pl7 tel me cant connect with...