I am working on an existing program in a Panel view 550 with panel builder 32. The original program had 1 page of products and we are adding 2 more pages. My problem is that when I am on the original page I can see the parameters change in the plc but when I go one of the new pages they don’t change. I think I need to somehow tell the panelveiw witch page is in control. Does this sound right to anyone if so how do I do that?
Panel View 550
- Thread starter Jaybird61
- Start date
Mickey
Lifetime Supporting Member
Post the PV's program. Zip it first, and someone can take a look.
Is the PV only communicating with one PLC?
Is the PV only communicating with one PLC?
Similar Topics
Hello all,
I have a Panelview 550 Cat 2711-K5A5 that has one Serial port ( RS-232). Which I can talk to via my cable via DF1. Which is weird...
Good evening partners, ist my first question on forum, i hope receive any answer.
I need make a cable DH485 for communicate an Panel View 550...
Hello, I have a panel View 550 that went bad , a new one has been installed , when you power up the PV it looks as it did before except there are...
Panel view CAT number 2711-K5A2
Getting fault "612 No active mode found on network"
Not sure if connected correctly and channel configuration is...
Hi All - I know that this has been covered off previously but I can't find the right solution.
I have a:
PanelView 550 2711-T5A2L1X 4.41
Connected...