Abhishek0505
Member
I practice on micrologix 1000 on that i want to glow three output from a single input without using counter. How can i ???
Doubt related to AB MICROLOGIX 1000.
- Thread starter Abhishek0505
- Start date
bernie_carlton
Lifetime Supporting Member + Moderator
XIC I:0.0/0 BST OTE O:0.0/0 NXB OTE O:0.0/1 NXB OTE O:0.0/2 BND
Youu may want to provide more precise information.
Youu may want to provide more precise information.
Abhishek0505
Member
OP
Thankyou sir for giving me information.
Similar Topics
Dear all, I need to know whether the way I am handling the below mentioned scenario is correct or not?
Scenario:
1. Through HMI(Graphics...
Hello Guys,
Hope everyone is doing well.
I have a general doubt about ladder programming.
The outputs are not getting energized when I used the...
Hi all, I'm working with FTVS and I'm trying to give a title to a dynamic popup that shows what device it is currently operating. I've seen that...
Hi all,
I'm quite new to the automation world. I've used a bit Tia Portal in the last month and now i have a new working in rslogix 5000.
From...
Hello everyone!
I'm currently programming a safety logic on Studio 5000 Logix Designer V33.00.00 and I wanted to know if there's a way to test...