Is there a way to investigate if there is a general fault in the FM352-1 camcard?
I know there is a function to read out the diagnostic buffer, but that doesn't tell you if there is at this moment still a fault.
You could also investigate the diagnostic interrupts, but that is trigger based, but I want some kind of continuous signal,
like there was a group fault bit in the IP264 S5 cam card.
I know there is a function to read out the diagnostic buffer, but that doesn't tell you if there is at this moment still a fault.
You could also investigate the diagnostic interrupts, but that is trigger based, but I want some kind of continuous signal,
like there was a group fault bit in the IP264 S5 cam card.