Trouble with Beijer E1071

Hi!

I have a E1071 from Beijer in use since 14 days.
But now it does not start the project anymore.

When i turn on the E1071, it writes: Status: Downloading...
After a short time it writes: Status: D/L timeout!

"Load project automatically on detection" in the memory card
settings is enabled, but there is no CF card or USB stick
plugged.

knows somebody this problem?

Use the dip switches (mouses keyboard) and do a hard reset to the HMI.

Go to:
http://www.beijerelectronics.com
Support
Support Online
Browse our database
Products
Operator Systems
Exter/E1000
Manuals
EXTER Operator Panels Service and Maintenance Manual (MAEN757C)

In there you will find the definition for each DIP switch.

Dip Switch 1 puts it in service mode switch it on then it boots into service menu when re-booted.
I assume you have a program for this if so delete project in service menu & either re-load using pc or if you have a copy on usb plug in usb stick, wait till detected then copy from usb to terminal, reset dip sw 1 & it should be ok.
By the way Beijers no longer support this as it is now supported by Mitsubishi.