C5Maverick
Member
- Join Date
- Mar 2004
- Posts
- 1
What is the AB solution to Cutler Hammers' R028 (Pulse Catch) I/O function? I am trying to convert to Micro 1000 and do not know how to convert R028.01 and R028.02.
Pulse Catch Inputs
- Thread starter C5Maverick
- Start date
ArikBY
Member
I dont know what is R28.01 and R28.02
BUT you can use OSR Fun to catch pulse if it not fast use high speed counter.
BUT you can use OSR Fun to catch pulse if it not fast use high speed counter.
jdbrandt
Lifetime Supporting Member
TOUGH ON A 1000
The only software solution is a IMM instruction.
If you had the STI function (you don't)...that'd be nice.
If you had the DII function (you don't)...that'd be best.
I'd say the only other way would be to buy a single shot timer
(SSAC, etc) and stretch the pulse so the PLC could
always find it.
The only software solution is a IMM instruction.
If you had the STI function (you don't)...that'd be nice.
If you had the DII function (you don't)...that'd be best.
I'd say the only other way would be to buy a single shot timer
(SSAC, etc) and stretch the pulse so the PLC could
always find it.
Similar Topics
Anyone know of a good TOF relay I can use to catch a high speed 24vdc (~100ms) and signal a 120vac input module?
This is a pig that goes through...
I have a Keyence LR-W500C full spectrum sensor that I am using to detect a splice in an expiring roll of paper. This sensor triggers a edge...
What is the fastest Pulse frequency that an AB 1769-IQ32 (CompactLogix Standard Input Card and not ua Highspeed counter) can detect reliably for a...
i Have an S7-200 plc and an single pushbutton.
when pushbutton is pressed for the first time output 1 should activate.
when pushbutton is...
Attempting to use the Pulse Catch function of the H2-CTRIO. I see the input clearly but get no output, even when I stretch the output time to 1...