Stephen Poole
Member
Gents have old ex40 to program but do not have software any help ??
EX40 Programming Software
- Thread starter Stephen Poole
- Start date
Welcome to the forum!
Using the Advanced Search feature under the Search button on the Blue-Green Toolbar above, type in EX40. You will find that there are numerous posts with information. There is also a Private Message Feature on this forum for direct contact with another member.
Using the Advanced Search feature under the Search button on the Blue-Green Toolbar above, type in EX40. You will find that there are numerous posts with information. There is also a Private Message Feature on this forum for direct contact with another member.
Last edited:
alexmcsheffrey
Member
Hi I have a hand held programmer if that helps??
Similar Topics
Does anyone have a copy of a EX40 or D100 Manual? I looked at Toshibas website and they don't have it listed anymore.
i am going to ask a selly question :
is there a parameter that might change the speed of the attached motor at a givin frequency either up or...
Hi Guys,
Does anyone know where I can buy, beg, borrow or steal a programming cable for the Toshiba EX40 plus PLC.
I have suitable software, but...
Does anyone have the actual pinout of the Toshiba EX40 Plus / D100 Programming interface/connector RJ45 socket please?
OR: Can anyone tell me...
Hi All
Newbie here so please excuse any tech gaffs!
I have been asked to look at copying a program from a faulty Toshiba EX40 to a new Unit as...