jim-garcia
Member
Hello Great forum !
I have problems with a micrologix 1500 My intention is to send pulses
using the PTO instruction output O:0/2 and O:0/3 on an BXB base
I can see my logic activated the output but not voltage come out
I have connected all comun at 24 vdc and my load comun negative
Im use a 2.2 k to limit the voltage to activated and 5 volts ttl
input of an stepper motor control
please somebody help me !!!!
I have problems with a micrologix 1500 My intention is to send pulses
using the PTO instruction output O:0/2 and O:0/3 on an BXB base
I can see my logic activated the output but not voltage come out
I have connected all comun at 24 vdc and my load comun negative
Im use a 2.2 k to limit the voltage to activated and 5 volts ttl
input of an stepper motor control
please somebody help me !!!!
