Prosoft MVI56-MCM

grisso13

Member
G
Join Date
Oct 2009
Location
casablanca
Posts
1
hello, I want know how to configure a module Prosoft MVI56-MCM contollogix with a variable speed electric brand vacon via Modbus protocol, plz it is very urgent

thank you

: Enseignant:
 
Last edited:

Similar Topics

E
MVI56-MCM Prosoft Modbus SLooooww?
Hi Guys, I have over a thousand registers setup in staggered polls from a device. Baud rate is at 19200. For some reason the slave wouldn't...
Replies
8
Views
3,009
Ken Roach
Ken Roach
W
prosoft mvi56-mcm slave port para setting?
Hi all, I want to use one port of MVI56-MCM as Slave port and set the following para correctly: BitInOffset Register value to offset address...
Replies
0
Views
1,697
wilsonzhu
W
B
Prosoft Flow Computer MVI56/69-AFC opinion
Hi everyone, Has anyone on the Forum used the Prosoft Flow Computer before? What was your opinion of it? I am quoting a well pad job and was...
Replies
3
Views
1,820
a062549
A
T
Configuring Prosoft MVI56-GEC to read ascii messages
Hi all, this is the first time I have posted on here, I have been reading with interest for a few years now. The problem I have is regarding...
Replies
1
Views
1,515
JohnCalderwood
J
G
ProSoft MVI56-PDPMV1
I am trying to communicate through this pro soft card with a GE Multilin 750. I think I need a certain GSD file, but cannot find it in the Prosoft...
Replies
5
Views
7,084
grider75
G
Back
Top Bottom