First analog program

Sadiq Al Zaman

Member
S
Join Date
Feb 2013
Location
karachi
Posts
17
this is my first time using the analog programming . i want to take the input from the thermocouple and display it, I'm using step7 and plc 314ifm. Can anyone help me in making the simulation and get some testing value in my simulation to check the results on my PC .
 

Similar Topics

ryangriggs
AB PLC - What happens to local Analog Output modules when entering program mode?
Hello, the PLC in question is 1769-L30ER. I have a local 4-20mA Analog Output module (1769-OF4CI), and also a remote ethernet PointIO analog...
Replies
0
Views
397
ryangriggs
ryangriggs
J
Correcting Analog Sensor Offsets in PLC Program
Curious, is it common to program in offsets to calibrate/correct analog sensor readings in certain applications? As an example, I have a couple...
Replies
11
Views
3,103
Lare
L
I
how to program Analog 4-20mA sensor in CLICK Software
Hi Guys, How is Analog 4-20mA Level sensor Programmed in CLICK software of Automation Direct? Which Instruction set.
Replies
5
Views
2,228
OkiePC
OkiePC
S
Analog input program
Help with a program setup. I am using a micrologix 1400 and inputting a 0-10VDC analog signal. My application is a part width measurement. The...
Replies
3
Views
1,878
DamianInRochester
DamianInRochester
B
analog configuration and program
I am wanting to use the 0-100 output data from a PID instruction to send out a 4-20mA signal from an analog ouput card to a Phase Angle controlled...
Replies
6
Views
1,798
sthompson
sthompson
Back
Top Bottom