Hello,
I am fairly new to this forum but I am hoping someone could offer some advice..
I am trying to get a CTC (Parker Automation) Powerstation P-1 to communicate via Comm Port 1 RS232 Null Modem with a Micrologix 1500-1764 LRP Proc. I have configured it to use Channel 1 DF1-Full Duplex w/ BCC error detection enabled. I know that Channel 1 is valid as I can communicate in and out of the PLC on it. I also know that my null modem is good because I have been able to download my app into the powerstation with it from my laptop. I am using Machine Shop's Interact Software to design my app. I am tryin to communicate via the Allen Bradley Data Highway Drivers on the Program. I was told to use SLC-5 drivers for the micrologix 1500. I can't seem to get the Powerstation to communicate with the micrologix 1500.
If anyone has any ideas, it would be greatly appreciated.
Thanks
Gem1
I am fairly new to this forum but I am hoping someone could offer some advice..
I am trying to get a CTC (Parker Automation) Powerstation P-1 to communicate via Comm Port 1 RS232 Null Modem with a Micrologix 1500-1764 LRP Proc. I have configured it to use Channel 1 DF1-Full Duplex w/ BCC error detection enabled. I know that Channel 1 is valid as I can communicate in and out of the PLC on it. I also know that my null modem is good because I have been able to download my app into the powerstation with it from my laptop. I am using Machine Shop's Interact Software to design my app. I am tryin to communicate via the Allen Bradley Data Highway Drivers on the Program. I was told to use SLC-5 drivers for the micrologix 1500. I can't seem to get the Powerstation to communicate with the micrologix 1500.
If anyone has any ideas, it would be greatly appreciated.
Thanks
Gem1