I have a Controllogix L64 and PLC 5/60.
I want to fetch data from CLX to PLC -5 and vice versa.
CLX rack has a 1756 - DHRIO card.
Since this is simulation setup I only have to devices on DH+. I have termination resistor on either ends.
Node ID on PLC 5 channel 1A is 7 and Link ID is 21
Node ID on CLX channel A is 4 and Link ID is 15.
DH+ Status Indicators on Both sides are Green Blinking. Which as per the manual means there no other nodes present on network.
I checked the cable conductivity and found OK.
I do not know if anything else needs to be configured.
Please help me troubleshoot.
Thanks in advance.
I want to fetch data from CLX to PLC -5 and vice versa.
CLX rack has a 1756 - DHRIO card.
Since this is simulation setup I only have to devices on DH+. I have termination resistor on either ends.
Node ID on PLC 5 channel 1A is 7 and Link ID is 21
Node ID on CLX channel A is 4 and Link ID is 15.
DH+ Status Indicators on Both sides are Green Blinking. Which as per the manual means there no other nodes present on network.
I checked the cable conductivity and found OK.
I do not know if anything else needs to be configured.
Please help me troubleshoot.
Thanks in advance.