todd.hadley
Member
Does anyone know how to make the wire numbers in an ACADE drawing match the PLC address the wire attached to?
ACADE wire numbers
- Thread starter todd.hadley
- Start date
TConnolly
Lifetime Supporting Member
Welcome to the forum.
There is an option in your wire number setup to use the PLC address.
There is an option in your wire number setup to use the PLC address.
JordanCClark
Lifetime Supporting Member
Not sure what version you have (mine is 2011). The command is AEPLCWIRENO. the button should be in the same group as the "regular" wire number tool.
- Select your wire number format. You may have to play a bit to get the results you want. I had to try a couple different ones before I got mine...
- Select the I/O module to process
- Select wires
todd.hadley
Member
OP
ACADE wires
Thank you worked well, never would've found it since I still use the classic layout.
Thank you worked well, never would've found it since I still use the classic layout.
Similar Topics
I have a new pc. After I install Autocad Electrical, how do I load my projects from my old pc?
If so what are your thoughts on it?
I just downloaded my update to ACADE 2015. So far with each successive generation I've grown more frustrated...
I'm looking to buy a new Dell Laptop, and thinking about the 64 bit system (Windows 7 Professional). I know that some of the older automation...
Does anyone have experience wiring this type of analog pressure transmitter up? It's 4 wires. 3 blacks and 1 green which I assume is earth...
Hi everyone, I need some help I new with omron plc. I using plc CP1L. When I do the program it's good and the plc is function as program. But when...
