hepworth07
Member
Hi all, new user.
New to PLC's aswell.
I am struggling to programme a Micrologix 1200 series C (L24BXB) to communicate with a serial slave display via channel 0. http://www.london-el...s/INT2S_F21.pdf
The serial slave display Accepts RS232 in ASCII format. Addressable 00 to FF. Able to extract data from complex strings. 300, 600, 1200, 2400, 9600 baud rate.
I am using RSLogix Micro Developer version 9.00.00
The programme counts an incremental encoder's pulses via the HSC, maths is performed on the pulse count, the final value is found in N7:0 on rung 20. Everything before rung 21 works fine.
I'm trying to get the serial slave display to show the value found in N7:0. This is where it goes wrong, I have tried multiple ways to create the programme and multiple ways of configuring channel 0. The display hasn't changed at all.
Please could someone view the program and tell me where I am going wrong?
New to PLC's aswell.
I am struggling to programme a Micrologix 1200 series C (L24BXB) to communicate with a serial slave display via channel 0. http://www.london-el...s/INT2S_F21.pdf
The serial slave display Accepts RS232 in ASCII format. Addressable 00 to FF. Able to extract data from complex strings. 300, 600, 1200, 2400, 9600 baud rate.
I am using RSLogix Micro Developer version 9.00.00
The programme counts an incremental encoder's pulses via the HSC, maths is performed on the pulse count, the final value is found in N7:0 on rung 20. Everything before rung 21 works fine.
I'm trying to get the serial slave display to show the value found in N7:0. This is where it goes wrong, I have tried multiple ways to create the programme and multiple ways of configuring channel 0. The display hasn't changed at all.
Please could someone view the program and tell me where I am going wrong?
Last edited:
