geoplc
Member
Anyone know a manufacturer that makes a 40 pin breakout board similar to the 1492-ifm40? I have seen them used before but havent been able to find one.
40 pin breakout board
- Thread starter geoplc
- Start date
ndzied1
Lifetime Supporting Member
LadderLogic
Member
Check Wago 289-507
Similar Topics
Hello:
I have to connect a RS232 Modbus RTU slave that only has Tx, Rx and GND signals to a Modbus RTU master.
However, all RS232 to RS485...
Hi All,
I came up with this for ramping the PWM pin on the micro 820. I'm new to ladder logic so I am not sure if this will even work? Once...
MELSEC A RS422 (25pin) <> iQR C24 Serial RS232 (9pin) - Simple PLC Communication
Communication from a MELSEC-A Series CPU (RS-422 – DB 25 Pin)...
M12 sensor plugs are widely used. I'm about making my own CAD symbols for sensor connections, and I'm not sure about including pin #5, which is...
In my FC I use an inout variable for the memory of a Set/reset.
When i call the FC i have the pin at the entry side of the block while i would...