PLC M2NCPU regarding

Nageshks19

Member
N
Join Date
Sep 2013
Location
*******
Posts
1
We have a PLC with Model No. M2NCPU - S1 and on cpu card as M3NMCA-4, with a set of MX11 & MY13 and MY10 I/O Cards.
I would like to know which is the software used for this and the communication cable details.
Also since it is outdated, which is the equivalent CPU for this unit.
 

Similar Topics

P
AB PLC, Rslogix 5000, alarm issue
Hi folks, in the alarm manager of Rslogix 5000, the tag-based alarm has been created. But when I tried to change the condition, it was found the...
Replies
0
Views
13
PLCbug123
P
H
PLC NAT Suggestions.
I know this topic has been brought up a few times, but i had some specific questions. I have installed several 1783-NATR devices and they have...
Replies
0
Views
36
HoldenC
H
H
No communication with PLC 90-70
Hello We have installed several G.E. Fanuc 90 70 PLC Everything was ok but suddenly we can not communicate anymore with any PLC with the software...
Replies
0
Views
31
Hazatov
H
Voltimus
IDEC PLC to PLC modbus communication
Apologies for not being the best IDEC programmer. I recently was doing some inspections on a site that had 3 FC6A IDEC processors. The issue is...
Replies
0
Views
51
Voltimus
Voltimus
P
PLC MICROLOGIX 1000 AND 1761-NET-ENI
"Hello! Good day! Excuse me, I have a question regarding the 1761-NET-ENI. RSLinx has already detected it but it's not connecting to the PLC...
Replies
4
Views
92
roxusa
R
Back
Top Bottom