imran17788pk
Member
Hi All,
I was running my program on FX3U PLC and monitoring it on write mode on GX-Developer. I left the computer for about 5 min and when I came back there was disconnection error on screen. When I tried to reconnect to PLC, I got the following error:
Cannot communicate with PLC for one of the following reasons.
Communications timeout
Cable error
Specified transmission speed not supported for connected PLC
Monitor condition set status is read by device
The project PLC and connected PLC are different.
< ES:0180840b >
I know that project PLC and connected PLC are same, and specified transmission speed is Ok and cable (USB SC09) is also Ok.
Does anybody know what is meant by "Monitor condition set status is read by device"? I'm almost sure that this is the problem I'm facing but I dont know how to resolve this. Can somebody please help and explain to me the solution.
Thanks.
I was running my program on FX3U PLC and monitoring it on write mode on GX-Developer. I left the computer for about 5 min and when I came back there was disconnection error on screen. When I tried to reconnect to PLC, I got the following error:
Cannot communicate with PLC for one of the following reasons.
Communications timeout
Cable error
Specified transmission speed not supported for connected PLC
Monitor condition set status is read by device
The project PLC and connected PLC are different.
< ES:0180840b >
I know that project PLC and connected PLC are same, and specified transmission speed is Ok and cable (USB SC09) is also Ok.
Does anybody know what is meant by "Monitor condition set status is read by device"? I'm almost sure that this is the problem I'm facing but I dont know how to resolve this. Can somebody please help and explain to me the solution.
Thanks.