setting up a poll job in cp1430 (s5) for SIX ethernet driver

normad

Member
N
Join Date
Oct 2013
Location
Sri Lanka
Posts
6
Hey,

Does anyone have an idea how to set up a poll job on the CP1430 so that the SIX driver installed on my pc can poll for data blocks on the CPU?
I tried setting up an active send job and a passive receive job but neither worked.
any help or guidance would be really appreciated :)

Thanks
 

Similar Topics

P
Modbus Poll communication setting?
I am trying to do very simple thing which is to write a value to PLC modbus address. I set the byte (Productivity Suite) to be modbus...
Replies
6
Views
2,718
mylespetro
mylespetro
Rsflipflop256
Setting up a modbus network on a DL262 Directlogic PLC with Siemens LMV 3 Burner controllers as slaves, eight of them, with OCI 412.10 Interface
Good morning fellow sea captains and wizards, I am being asked to do the above and obtain 4 values from each slave, I know about the MRX and MWX...
2 3
Replies
32
Views
661
Rsflipflop256
Rsflipflop256
T
SETTING UP I/O USING LOGIXPRO RS 500 EMULATOR
SELECTED NEW FILE SELECTED PROCESSOR TYPE SELECTED I/O CONFIGURATIONS IM UNABLE TO CONFIGURE MY I/O’S. I HAVE A PAPER COPY OF A PROGRAM AND I...
Replies
0
Views
81
TFLARIS
T
L
Resetting old RSLINX Master Disk floppy
Does Rockwell still offer reset codes for old school Master Disk floppy's? In a bind and need to reset the activation disk soon and to be pointed...
Replies
9
Views
230
LMDAVE
L
U
Setting up WAGO PFC 200 750-8216 as a Profibus Slave
Hello, I am in possession of a WAGO PFC 200 750-8216 which I was successfully able to set up as a Modbus RTU Master to a slave device using...
Replies
0
Views
79
udit_91
U
Back
Top Bottom