Howdy. I've got a CP1L here with CP1W-CIF11 RS-485 interface module installed and I'm trying to teach myself how to transmit ASCII data, so far unsuccessfully. The ultimate goal is to transmit ASCII commands to a stepper controller, but right now I have the output going into a RS485>RS232 converter --> RS232>USB converter, and trying to monitor any data transmitted by the PLC in a serial terminal window when I close input 0.07. I'm not getting anything.
Does anybody have some guidance for me, or perhaps a sample program that I dig through to figure it out?
Thank you.
Does anybody have some guidance for me, or perhaps a sample program that I dig through to figure it out?
Thank you.