g.mccormick
Lifetime Supporting Member
I'm trying to find switches (prox or plunger) that will go down to atleast -20F preferably down to -40F. Anyone know of any?
Cold temp switches
- Thread starter g.mccormick
- Start date
g.mccormick
Lifetime Supporting Member
OP
Gil47
Member
We use a Cutler Hamer E50 series switch in -40 deg
Link
http://www.farnell.com/datasheets/1485638.pdf
see page 3
Link
http://www.farnell.com/datasheets/1485638.pdf
see page 3
Similar Topics
What b&r cold restart does? does its erase program permanently?
Hi all,
Looking for a temperature sensing solution for determining ambient temperature in the frigid Canadian winters. Discrete outputs are fine...
I'm running a distribution terminal on ControlLogix 5580. It's been stone cold where we are and we haven't run some of this equipment since being...
Hello,
I am using the DCS instruction for a simple emergency stop detection. Actually I set the "cold start type" to automatic.
This means when...
Hi all, I am planning to put a AB servo in a freezer environment -20f or worse. My hope is some of you have experienced this and have ideas on how...
