Greetings,
I am currently trying to program a basic temperature loop for a Allen Bradley Micrologix 1000 plc.
I have installed :
RSLogix Micro Starter Light
RSLinx Classic light
RSLogix Emulate500
All programs are running and I have programmed a simple start stop rung to prove they system is working, which it is.
I have also trialled an SCP block, which is also working.
My problem comes when trying to use a PID Block.
My block is set-up as follows:
PID FILE = PD10
Process Variable = I:1.0
Control Variable = N11:0
I cannot get the PID block to change state to "Enable" so "EN" flag =1
I have a feeling it is something to do with the emulator software and the debugging report that the emulate software uses.
Does anyone have any ideas on how I might get the emulator to work with the PID block??
I have attached a screenshot showing the program, rung, I/O, EMU & Linx
Any help greatly appreciated.
Thanks
Bwengis
I am currently trying to program a basic temperature loop for a Allen Bradley Micrologix 1000 plc.
I have installed :
RSLogix Micro Starter Light
RSLinx Classic light
RSLogix Emulate500
All programs are running and I have programmed a simple start stop rung to prove they system is working, which it is.
I have also trialled an SCP block, which is also working.
My problem comes when trying to use a PID Block.
My block is set-up as follows:
PID FILE = PD10
Process Variable = I:1.0
Control Variable = N11:0
I cannot get the PID block to change state to "Enable" so "EN" flag =1
I have a feeling it is something to do with the emulator software and the debugging report that the emulate software uses.
Does anyone have any ideas on how I might get the emulator to work with the PID block??
I have attached a screenshot showing the program, rung, I/O, EMU & Linx
Any help greatly appreciated.
Thanks
Bwengis