Terry Boblitt
Member
New to me--I need to upload a program out of a 600 plus. I currently have FactoryTalk View Studio open along with the transfer utility. So where do I need to go now/put in the box's.
Thanks Terry
Thanks Terry
panelview 600 plus upload
- Thread starter Terry Boblitt
- Start date
Terry Boblitt
Member
OP
I finally got it up loaded to my desktop as a zip file. I'm going to assume that's right.
Source storage type--internal
source file----------file name then mer behind it(OK)
upload as------------your file name
Destination folder---desktop
If I send this file to someone can they make changes to it. I've used panelbuilders--this is new to me----wanting to learn & not have screw something up.
Thanks to all
Source storage type--internal
source file----------file name then mer behind it(OK)
upload as------------your file name
Destination folder---desktop
If I send this file to someone can they make changes to it. I've used panelbuilders--this is new to me----wanting to learn & not have screw something up.
Thanks to all
Terry Boblitt
Member
OP
Can you,please clarify you answer.
Thanks Terry
Thanks Terry
Similar Topics
Hi
I have a number of the older PanelView Plus 600 HMI's (2711P-T6C20D, Ser D) that I want to update to the latest firmware. I believe that the...
Hello ,
I have an HMI of PV+ 600 (2711-T6M5D) Ser A Rev B, This HMI doesn't have the ethernet port i have to take backup through communicate...
Hello all,
I copied the MER file from one PanelView Plus 600 to another one, using a USB drive.
On the new HMI, I copied the MER file to the...
Hi all,
I have an old PanelView Plus 600 (2711PC-T6C20D8) that I am repurposing on our site - I have flashed the firmware to ME version...
Hello Team,
I have a question, I have been working with a panelview plus 600. But I have deleted all the .mer directly from the HMI, after that I...