GOT1000 HMI to Wago 750-881 PLC TCP MODBUS driver

gmcgivern

Member
G
Join Date
Nov 2012
Location
Newry
Posts
5
I am trying to connect a GOT1000 HMI to a Wago 750-881 PLC using the TCP MODBUS driver but can't read the registers

I'm using 20 registers from %MD0 in the Wago and have tried to read from 40001 in the HMI but nothing

Note, when I try this on an E1100 HMI reading from 1:MW1 it works OK

Any ideas ?

Regards
 

Similar Topics

S
Mitsubishi HMI GOT1000 Displays
Just Wondering how easy or hard it is to use a GOT1000 with RsLinx and RSLogix500? I have ran across a couple units and would like to try to use...
Replies
12
Views
2,395
SamTheLightMaster
S
R
Mitsubishi HMI GOT1000 (GT1055)
Hi, I am trying to program Mitsubishi GOT1000 Series HMI (GT1055-QSBD) using GT Developer 2 (V2.18U), however when I try to write program to HMI...
Replies
0
Views
3,390
Rumiat
R
A
Mitsubishi GOT1000 HMI
Dear Friends, I have encountered a situation where in I have to establish a communication between a Mitsubishi HMI GOT 1000 and EZAutomation PLC...
Replies
2
Views
4,081
Abdul03
A
mrtweaver
Mitsubishi GOT1000
I am still fairly new to Mitsubishi. So I am hoping some guru or someone here will be able to answer these. I have GT Designer 3, when i connect...
Replies
1
Views
1,539
Wasan
Wasan
W
GT1655-VTBD GOT1000 wiring issue
Good Afternoon, Our GOT1000 HMI was wired incorrectly when the vendor installed them. +24V was on ground and ground to +24V post. Everything was...
Replies
2
Views
1,765
WebbyNY
W
Back
Top Bottom