SSJVegetto
Member
Hello everyone,
I have a question relating the PID insruction. I have set its properties but when the rung is activated, the output does not change at all. Can someone help me with this?
I have inserted the PLC code as an attachment. I use the bit START_TEST to make the code run.
Thanks in advance,
Bob
I have a question relating the PID insruction. I have set its properties but when the rung is activated, the output does not change at all. Can someone help me with this?
I have inserted the PLC code as an attachment. I use the bit START_TEST to make the code run.
Thanks in advance,
Bob
Last edited: