GX IEC Developer 7

Hi

Does anyone know if its possible in IEC Developer to move/copy '0' to an array of Bools (31 in total)?

Instead of having a ladder that has 31 reset coils i'd like to move a DINT full of zeros to the Mbits........or something along those lines.

regards
Shaun

Hello,

I use GX Works 2 but look in the programming manual for the BMOV command.
I think that is what you are looking for.

Hope this helps
Dave

Thanks for the info Dave.

I tried for a while to input that command but couldn't escape the mismatch error however, i've since found that a zone reset (ZRST) command is the way to go.

Many Thanks
Shaun