Hi everyone, I'm new to the forum and just got back into this field so any help would be appreciated.
I am trying to use a MicroLogix 1500 to control a ICS 4895 GPIB CONTROLLER to a Waveform Generator. Using RSLogix 500!
I'm using a AWA command to write the ASCII instructions to the GPIB controller but I can’t seem to be able to populate the data into the ST Data file area?
Any help would be appreciated.
Thank you,
I am trying to use a MicroLogix 1500 to control a ICS 4895 GPIB CONTROLLER to a Waveform Generator. Using RSLogix 500!
I'm using a AWA command to write the ASCII instructions to the GPIB controller but I can’t seem to be able to populate the data into the ST Data file area?
Any help would be appreciated.
Thank you,