unsaint32
Member
the parameter is for motor rated current. The range is 10 - 200% of drive rated current. But the actual value is displayed something like 0.8. So, 0.8 = 80%?
omron v1000 drive parameter e2-01
- Thread starter unsaint32
- Start date
paraffin power
Member
The range is 10-200% of inverter rated current, but the value you enter is in Amps.
Pp
Pp
Similar Topics
The B1 and B2 terminals are for thermal relay AND for braking resistor. Doesn't this mean if the thermal relay trips I have no dynamic braking? I...
HI; i have in stock PV1000 DH+ ,and i want install this PV with OMRON plc CS1J CPU44; is there possible ? if is ok ;please descript a...
Hi all,
Currently having trouble getting a speed reference to write over modbus to an Omron M1...
I can successfully write a run command and...
Hi There,
I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
Hi dear . I have a system with cj1m cpu11 etn. previously NT 5z HMI was connected with plc. recently my old HMI got damaged. I want to replace it...