1761 net eni steady fault solved

http://www.plctalk.net/qanda/showthread.php?p=588476

-- Oiginally Posted by shawn_75 View Post
Attempt a firmware update over ethernet to 3.22 (I think). I've never had an ENI fault steady red so I don;t know if this will work. All my series D ENIs began behaving quite nicely when I updated from 3.21.---

Thanks. Steady Red Solved.

Before the upgrade 3.22, Net Eni Behavior
No RS232 Communication works
No Ethernet Comunications works
No com re-director Works
No Net/ENI Utility Works via (ethernet and RS232)
Reset Net/Eni via Programming ladder Logic over RSLogix 500/5000.(No works)
No Boot DHCP WORKS.
Every moment when Connected Net/Eni to SLC or L34... FAULT the controller
NO RSLinx Detection.
When I add the IP Address on the Web browser, web page blocked (No Works)

The only thing that it works were the CMD ping. ( only works whith the last IP in this case was 129.123.226.30)

Upgrade
Only Download the firmware.
Open and put the last Ip Addresss 129.123.226.30


After Upgrade.

All the stuff that I mentioned runs perfect.

I hope these info helps others.

Regards.


-AJ:book:

I keep on telling that the best Net Enis are the ones in the garbage can. I stopped using them several years ago.