CM CANopen for SIMATIC S7-1200

Jirrr

Member
J
Join Date
Jan 2009
Location
Czech
Posts
167
Hi everybody,
is there any one who has any experience with
CM CANopen extension module for the SIMATIC S7-1200...I would like to use one,but have no experience with it....
Thanks You very much for any answer...
 

Similar Topics

S
AB Micro850 CANOpen Communication
Hi, I have a AB Micro850 that needs to write and read on a CANOpen network with a Danfoss Display and Schneider Motor Drive 110kW, I'm using...
Replies
1
Views
371
Ken Roach
Ken Roach
A
CanOpen diagnosis tools-software
Has anyone knowledge of CanOpen diagnosis tools-software. I found this of Helholz : https://www.helmholz-benelux.eu/product/can-bus-tester-2/ I...
Replies
1
Views
966
AlfredoQuintero
A
A
Gateway Ethercat - CanOpen
Does anyone have references for gateways Ethercat - CanOpen? Where the master will have Ethercat protocol and the devices CanOpen. The gateway...
Replies
4
Views
1,174
AlfredoQuintero
A
D
Schneider Modicon M340 CanOpen error
Hi, I'm configuring the M340 controller with ATV320 inverters via Canopen. Everything was fine until today, when after starting the electrical...
Replies
1
Views
1,332
chud
chud
A
Beckhoff EL6751 and CANOpen device
Hello, We are trying to use an EL6751 with a CANOpen device. To start the connection with this device, we need to send a broadcast message...
Replies
0
Views
1,301
adems
A
Back
Top Bottom