Im hoping someone might be able to provide me with an example of bringing two axises in to a home switch (X,Y), then moving them out to a set position. Im using step and direction along with the PTO of a ML1100. Any help is greatly appreciated!
ML1100 Stepper Home Position
- Thread starter udc1
- Start date
widelto
Member
See attached file.
In your SLC500 software there is a directory called samples, there you can find some examples of PTO instructions.
In your SLC500 software there is a directory called samples, there you can find some examples of PTO instructions.
Last edited:
Similar Topics
Does anyone have schematics (and PLC program) for connecting a stepper motor to a ML1100 (or any of the Micrologix line). I haven't found any A-B...
I'm looking to implement a low-cost, efficient method of communicating some integer values to an R30iB robot from a Rockwell 1100 PLC.
I am not...
Hello all,
I am trying to setup my MicroLogix 1100 as a modbus RTU master for a modbus network containing multiple modbus RTU slaves. I currently...
We have a machine that keeps losing its program at random intervals; sometimes 2x-3x in a shift, sometimes will go over 1wk without issue. I had a...
Just asking for clarification here, but from my research all I need is a 500 ohm resistor across the AI and the common? Heres my schematic.
I...