sparkytex
Lifetime Supporting Member
Hello guys,
I need to change the Range of an input to one of my PID controls to MINI-2986 MAXI-4095 instead of MINI-0 MAXI-4095 on RSLogix 5. I've read that you can fault the processor changing the MINS and MAXS values while running but cannot find anything about changing the MINI or MAXI value while running. By changing this it wont put my setpoint out of range either. Is there a chance in faulting the processor changing this value?
thanks, Tex
I need to change the Range of an input to one of my PID controls to MINI-2986 MAXI-4095 instead of MINI-0 MAXI-4095 on RSLogix 5. I've read that you can fault the processor changing the MINS and MAXS values while running but cannot find anything about changing the MINI or MAXI value while running. By changing this it wont put my setpoint out of range either. Is there a chance in faulting the processor changing this value?
thanks, Tex