1734-aentr
- Thread starter bwiring
- Start date
Ken Roach
Lifetime Supporting Member + Moderator
Which version of RSLogix 5000 are you running ? I think that the module profile for the Series B didn't get included until Studio 5000 v21.
It's straightforward to add it as an Add On Profile, though: start at the Downloads page and navigate through the Add-On Profiles. There are separate AOPs for the 1734-AENT and the 1734-AENTR.
https://download.rockwellautomation.com/esd/download.aspx?downloadid=addonprofiles
It's straightforward to add it as an Add On Profile, though: start at the Downloads page and navigate through the Add-On Profiles. There are separate AOPs for the 1734-AENT and the 1734-AENTR.
https://download.rockwellautomation.com/esd/download.aspx?downloadid=addonprofiles
Similar Topics
Hello
The plant is running and there is no shutdown nowadays therefore I can add 1734- AENTR and its card while PLC is in Run?
I do not wanna...
Hello all.
I have a remote that uses a 1734-AENTR series C.
We had to change it to a new one and, after adjusting the IP and number of slots...
The issue we have is that the IT2I thermocouple card and the RTD temperature sensor card connected through a point IO AENTR is constantly trying...
Hi guys, I have just recently purchased a 1734-AENTR module so that I could learn how to configure it through LogixDesigner and establish comms...
Hi there!
I've been looking for some fault codes table for the 1734-AENTR adapters, since I'd like to show a message in HMI with some...