jrcarrerar
Member
Hi
I was downloading a program to a Twido TWDLCAE40DRF PLC base when suddenly i got disconnected. It wasn't a power fluctuation, the Twido PLC lost communication. Now, when I power on the PLC the RUN, ERR and STAT leds blink at the same time, in an strange pattern. The troubleshooting guides from Schneider aren´t very informative. I can't connect via Ethernet or Serial, and no matter how many power cycles i make, the error is still there. I tried to update de Firmware, but as I can't connect to the PLC this option wouldn't work.
I leave a video link where the blinking can be seen:
https://www.youtube.com/watch?v=gsb8xDjWZms
Any idea or commentary would be appreciated, thanks.
I was downloading a program to a Twido TWDLCAE40DRF PLC base when suddenly i got disconnected. It wasn't a power fluctuation, the Twido PLC lost communication. Now, when I power on the PLC the RUN, ERR and STAT leds blink at the same time, in an strange pattern. The troubleshooting guides from Schneider aren´t very informative. I can't connect via Ethernet or Serial, and no matter how many power cycles i make, the error is still there. I tried to update de Firmware, but as I can't connect to the PLC this option wouldn't work.
I leave a video link where the blinking can be seen:
https://www.youtube.com/watch?v=gsb8xDjWZms
Any idea or commentary would be appreciated, thanks.