get position ( length ) with 1756-hsc/A or B

raouul

Member
R
Join Date
Oct 2014
Location
Montréal
Posts
1
hello everyone

I am new with allen bradley, i am using Rslogix 5000 with rsemulate 5000 v19.
i want to use 1756-hsc/a in my program to measure length . I configure my hsc as an encoder (x4) without sample rate and mode storage. so as Iam just emulating (no real hardware) I dont know where i can read my counter and how to convert it to length.

Thank you
 

Similar Topics

H
Studio5000 - Multiply based on position in array.
I have an array of 55 REAL values. Is there a way to multiply based on the array location ? I have 55 transfer belts that are equally spaced...
Replies
3
Views
152
HoldenC
H
R
Hydraulic ram position / pressure control
Hi All, I could do with some advice on a hydraulic control system. It is necessary for me to accurately position a vertical hydraulic ram with...
2 3
Replies
34
Views
1,898
Peter Nachtwey
Peter Nachtwey
J
Rs500 sqo hold position after stop and restart
Hello I am trying to make a program work with a sqo instruction .The process has 5 steps ,and a starting step of zero.There should be 8 sec...
2
Replies
17
Views
1,045
drbitboy
drbitboy
K
ISA 5.1 Refresher - Analog Position Feedback (P&ID Tag)
It's been a long time since I've had to think of P&ID tag nomenclature myself (and not gone along with some scheme devised by someone else). I've...
Replies
1
Views
231
g.mccormick
G
B
Best Practice - What controls recommended for a 2-position turntable
Out of interest, I'd like some thoughts on what would be considered best practice with regards to a 2-position turntable control scheme (see...
2
Replies
17
Views
1,131
Peter Nachtwey
Peter Nachtwey
Back
Top Bottom