Any suggestions for getting a Yaskawa iQpump 1000 AC Drive communicating with a Red Lion Data Station Plus. The drive has an Ethernet/ipcard (SI-EN3D) installed and communicates flawlessly over the LAN with the Yaskawa Drive wizard software. We’ll be adding several Yaskawa drives operating irrigation pumps to an existing Data Station Plus setup that is currently monitoring Siemens S7-1200 plc’s attached to other irrigation equipment. Any help would be appreciated.
Red Lion Data Station Plus and Yaskawa iQpump 1000
- Thread starter msi124
- Start date
wolverine1981
Member
Good Morning,
Check out the links below. In the Yaskawa link there is a technical manual and a cheat sheet for the SI-EN3 & SI-EN3D.
https://www.youtube.com/watch?v=dtk4Wu3ggCg
https://www.yaskawa.com/pycprd/products/specialty-pump-drives/drives/iqpump1000/tab4/link40
https://www.youtube.com/watch?v=NnxnkqsBkCs
Hope This Helps
Tom
Check out the links below. In the Yaskawa link there is a technical manual and a cheat sheet for the SI-EN3 & SI-EN3D.
https://www.youtube.com/watch?v=dtk4Wu3ggCg
https://www.yaskawa.com/pycprd/products/specialty-pump-drives/drives/iqpump1000/tab4/link40
https://www.youtube.com/watch?v=NnxnkqsBkCs
Hope This Helps
Tom
Last edited:
Similar Topics
I`m looking into using Red Lion Data Station, do someone have experience with
limitation on number of tags and performance?
Hi I have been using Red Lion products for some time, I had a thought over the bank holiday weekend, As you do.
It would be nice if whenever a...
Hi, I'm trying to get values from 8 encoders using a 2-wire bus RS485 connection to a Red Lion Data Station. These will ultimately write values to...
Hey everyone!
Pretty new to Red Lion, and am setting up a data logger on my HMI application. My boss is logging data on another HMI and I've...
Hi All,
I am hoping someone can help. I have setup a Red Lion Data Station (DA30D, Crimson 3.1 Build 3112) to log data from several Allen...