Micro 830 PLC- Master- Slave

Join Date
Feb 2012
Location
UK
Posts
57
Hello Guys,
I have two different Micro 830 PLCs, namely 2080-LC30-100QWB and other one is 24AWB. I want to make one Micro 830 as Modbus Slave and another Micro830 as Modbus Master and want to pass data from Slave to Master. Both PLCs have 2080-Serial ISOL card for communication.With Connected Components Workbench Software I could setup PLCs as Master and Slave and on Slave PLC I could do the Modbus I/O mapping to send Data over modbus. I cant figure out to receive data in Master. I using Modbus485-RTU network.

Any suggestions please.

Thanks in advance for help.
 
There is MSG_MODBUS Instruction in Connected workbench software, One configured properly, it will talk to all the slaves on the network and brings back the requested data.
 

Similar Topics

HI, i am wondering if micro 830 using controlled components workbench has a way i can uttilize a TOF from an old slc 150? In addtion If I...
Replies
1
Views
2,730
Hello friends We communicate between Micro 830 and a card that control DC motor via modbus RTU. We do not have any problems in communication. But...
Replies
1
Views
1,514
Hi, Its possible communicate between kinco hmi (mt4404t) and Micro830 through a serial line ( rs232/485 ) ?
Replies
2
Views
1,536
Customer has a Micro 830 (2080-LC30-16AWB) and a Panel View component C200 (2711C-K2M). They want to add remote connectivity. I was thinking of...
Replies
9
Views
2,661
how do I make a timer timing bit in a micro 830 program using connected components?
Replies
5
Views
1,587
Back
Top Bottom