sabertooth
Member
Hii.....iam using omron cp1e plc....want to display some values in hyperterminal by rs 232.....anybody knows the code...im using txd instruction....
Omron plc
- Thread starter sabertooth
- Start date
Since you are using the TXD instruction in the PLC. You do not need any other code.
Check to make sure that your cable connection to the PLC is correct.
Check your communication settings: 9600 Even 7, 2 is usually the default for Omron
Check your transmit light on the unit to see if it flashes when sending data out of the port.
Note: You must send ascii characters out of the port.
http://accautomation.ca/what-everybody-ought-to-know-about-plc-programmable-logic-controller-numbering-systems/
Regards,
Garry
http://www.accautomation.ca
Check to make sure that your cable connection to the PLC is correct.
Check your communication settings: 9600 Even 7, 2 is usually the default for Omron
Check your transmit light on the unit to see if it flashes when sending data out of the port.
Note: You must send ascii characters out of the port.
http://accautomation.ca/what-everybody-ought-to-know-about-plc-programmable-logic-controller-numbering-systems/
Regards,
Garry
http://www.accautomation.ca
Similar Topics
Hi There,
I have couple of Omron PLCs connected on my kepserverex and my intouch reads data from kepserverex. I have been observing that roughly...
I am working on a project using a NB screen and NX1P2 PLC.
I am having a really hard time getting a real number to properly translate through to...
Our plant manger/my boss wants each line to display the takt time above the line. I am trying to research the cheapest way to do this. Our plant...
I have PLC Omron CJ2M with OD211 module. I want to use the pulse output and PWM output and this module. But i confuse how to activated this, i...
I have a project to control the speed of motor DC using PWM Output on PLC and when im on working i have a several trouble and of of them is the...
