RS-485 communication SEW MoviTracB

Gents,

I've to configure some SEW MoviTracB VFD's.
I can do this on the front panel, or with MotionStudio.
The MoviTracB has a RS485 connection, and I've a Array A-1521 USB to serial converter.

Has anyone experience in configuring a SEW MoviTracB with this Array A-1521 converter and MotionStudio?
How do I need to wire the Array A-1521 to the VFD?

Is it possible to up -and download the VFD configuration this way?

Thanks in advance!

Jack

Anyone any experience on this?

Thanks in advance!

Jack

http://download.sew-eurodrive.com/download/pdf/16791215.pdf

I have not used this equipment, but it says that it is possible. Look at 12.1- Serial (RS485) communication via interface adapter

Keep in mind that not all USB converters are the same. I have tried a few that did not work. Sabrent is the one that I found work for communicating with PLCs.

Regards,
Garry
http://www.accautomation.ca

Thanks Garry,

I'll do some tests according the manual you attached which is different than all the manuals I've read so far.

Jack