PF 755 Firmware Flashing Help

Tim Ganz

Member
Join Date
Dec 2010
Location
Dallas, Texas
Posts
674
We had to replace a PF 755 drive in a system this morning and the firmware is about 6 majors higher than the other drives on the machine.

The boss wants me to flash the drive and HIM firmware to make them all match.

After I flash the new firmware to the drive to I have to download the drive parameters back to the drive or are they retianed through a firmware update?

Does the firmware update wipe out all the drive parameters?
 
I have never done a Drive Firmware Update but I would bet money that the parameters are wiped out after the flash.
 

Similar Topics

Hello guys, I am new to this forum and have some problems with my PowerFlex755 EENET frequency inverter. I want to do a point to point...
Replies
0
Views
47
Powerflex 755, running 2 weeks, and faulting with code 17 input phase loss.
Replies
3
Views
156
Hi All, This is my first PowerFlex 755 drive setup and I am having an issue with when I start the drive it runs at my minimum speed 5Hz, but...
Replies
10
Views
344
Need some help trying to set the IP address in a Powerflex 755 with a 20-HIM-A3 installed. Drive has an embedded Ethernet card from the factory...
Replies
4
Views
201
Hello, guys I am having an issue with Pflex 755, when it is stopping the motor, it is going on fault 9 " Transistor Over Temp". Has anyone dealt...
Replies
1
Views
411
Back
Top Bottom