Help Very needed

osamamalhy

Member
O
Join Date
Jan 2006
Location
alex
Posts
89
Greetings

I do have the following problem
I need to down load and application to Siemens OP17
I used to ProTool Pro V6.1
I am using the original Siemens configuration cable (serial cable), my laptop equipped with Serial Port
Operating system of my PC is windows XP

OP in the transfer mode

I could not mange to do down load of the application
I try many baud rates
all time communication interrupts

any advice ?
 

Similar Topics

afm
Automation studio help: averaging analog sensor values every 2 seconds
Hi, I have a bit of PLC experience in Siemens and have unfortunately been blessed with working on Automation Studio and B&R which has been a big...
Replies
5
Views
1,363
drforsythe
D
B
Need Help with Controllogix work cell, need a very seasoned vet
My company has a workcell that has 1756-l61 plc , controllogix with multiple communications running, Ethernet, controlnet, devicenet, dh-rio...
Replies
6
Views
2,091
JeremyM
JeremyM
V
Dual Compressor PLEASE HELP DUE VERY SOON!
Part 2 – Alternating Compressors when Loading is Light In this part, each compressor is to take its turn bringing the storage tank pressure back...
Replies
13
Views
4,813
daba
D
nochehuatl
FactoryTalkView SE: Need Help, How to randomly change display screens every 10 sec ?
📚 Working on a project where the HMI will display the production plant counts of all lines on one screen. After 10 seconds change to display...
Replies
10
Views
3,731
nochehuatl
nochehuatl
fhervrylesestoso
Need Help for this very basic question
using S7-200 PLC for this case... Heres my problem... I have 2 NORMALLY OPEN Push Buttons PB1 is I0.0 PB2 is I0.1 PB1 and PB 2 are connected in...
Replies
5
Views
1,521
fhervrylesestoso
fhervrylesestoso
Back
Top Bottom