Thermo Fisher Weighbelt integrator MT2201 PM

grnick50

Lifetime Supporting Member
G
Join Date
Nov 2010
Location
Ptolemaida
Posts
332
Hello all,

I am doing a rebuild and I need to transfer two Thermo Fisher weighbelts (Model MT2201 PM) from an old system to a new one.
For that I need to use their Profibus connectivity to a S7-300 PLC. To do that I need to have the GSD file of the weighbelt. I am searching the web and I cannot find that file.
Has anyone have any experience with that? Does anyone have the GSD file or a link and whiling to share?

Regards

1.jpg 2.jpg
 

Similar Topics

M
Need advice, IR thermo sensor & Datalog
Hey guys, I'm looking for some advice for my project. We are trying to datalog the temperature of a wooden log, it can vary from 35C to 70C. and...
Replies
3
Views
1,672
Martindag
M
X
FX3U (le3u) thermo probe?
Hi, I`m new here and also in "plc world", I`m owner of FX3U clone PLC https://www.lollette.com/le3u-24mt-6ad2da-plc-controller.htm with HMI...
Replies
11
Views
2,846
xman
X
N
Retransmission of Thermo Couple signal
I have a one thermocouple that is connected to temperature module 1769-IT6 that accept thermocouples on a compact logix 1769-L33E chassy.I have a...
Replies
1
Views
1,401
DwSoFt
D
B
Thermo ramsey AB RIO Interface assitance
I have the following equipment. 3 - thermo ramsey 2301 intergraters each with AB RIO Board installed. 1.C3 scale, 230k, Rack 1.1 2.c23b scale...
Replies
4
Views
3,683
burrowsj78
B
M
Thermo Couple
HI EVERY BODY I NEED GOOD PROGRAME BY SIEMENS S7 200 TO CONTROL WITH TEMPRETURE ON THESET VALU CAUSE ON OFF DOSE NO KEEP THEVALUEIN SET ANDTHERE...
Replies
0
Views
2,149
MNJO5
M
Back
Top Bottom