Abb Kt94- Kt93

wsjron

Member
W
Join Date
Jul 2004
Posts
2
I have a question regarding arc net on ABB KT93 and KT94 PLC’s. I am trying to connect two of PLC,s together and make them communicate using the built in arc net. I have the ASEND and AREC setup along with the AINIT and APOLL. I must have something wrong because when I send over a message I get a UJOB out put on the AREC block.
I had a setup like this running last year, but I can’t remember how I did it.
Any information would be great.
thanks
ron
 

Similar Topics

EICS
ABB PS501 Control Builder Plus V2.3 Install - anyone use it or know of it
does anyone have an install or know if/where i can download it for the following "ABB PS501 Control Builder Plus V2.3 " the software was a free...
Replies
2
Views
88
ojz0r
O
S
IE5 ABB motor and VFD
Hello, It is mandatory to use VFD IF i use IE5 electrical motor? What happens If connect it directly as delta without VFD? Please look at motor...
Replies
1
Views
136
kamenges
K
R
ABB ACS800-07 VSD fault on ramp up between 98 and 100%
Hi hoping someone can assist me with current issue I am experiencing with an ABB drive. Problem I’m experiencing is a ABB drive supply a large...
Replies
4
Views
208
BryanG
B
R
ABB AC500 (PM573-Eth) PLC Program Backup
Hello all, I have an ABB PLC (PM573) and it has without MC card. I need to take backup from PLC to PC (in automation builder v2.7 ). My...
Replies
10
Views
430
arpus4KM
A
O
Remote Connection to ABB MOD300 OPC Server - Difficult or Impossible
Folks, I have a client with an old ABB Advant / MOD300 system (v14.4). Around y2k I installed the ABB Industrial IT MOD300 OPC Server 1.1/2...
Replies
1
Views
178
odwyerpw
O
Back
Top Bottom