Setting up S5 Com 143 Config

russg

Member
R
Join Date
Aug 2012
Location
UK
Posts
275
I'm attempting to set up a CP 143 card at the moment. Does every send and receive block created in the S5 have to have a Data link connection file set up in the CP 143? And is this only the .143 file or are other files important too?

Thanks

Russ
 

Similar Topics

A
Micom p225 relay setting
Actually I need any reference setting /setting file (s1 studio) of MICOM P225 motor protection relay as I do not have any Areva support here. If...
Replies
0
Views
1,215
abhirupbera
A
R
1769-L36ERM Ethernet Com Path Setting
Hi everyone, I´m trying to upgrade a machine that has an 1769-L32 to a 1769-L36ERM but there are some devices like RTA 435 and Balluff RFID...
Replies
1
Views
2,507
Ken Roach
Ken Roach
J
setting up rio com link
hello, I am having some issues with getting my 1747-SN to communicate with some Flex IO modules via RIO.. I am not familiar with this.. and have...
Replies
9
Views
1,984
jlash
J
R
Problem setting up com port in DirectSoft
I am installing DirectSoft Ver 5 (Direct Logic) in my new laptop. When I go to set up the communications link between the laptop and the PLC, the...
Replies
10
Views
7,252
rwy34ils
R
Rsflipflop256
Setting up a modbus network on a DL262 Directlogic PLC with Siemens LMV 3 Burner controllers as slaves, eight of them, with OCI 412.10 Interface
Good morning fellow sea captains and wizards, I am being asked to do the above and obtain 4 values from each slave, I know about the MRX and MWX...
2
Replies
20
Views
153
Rsflipflop256
Rsflipflop256
Back
Top Bottom