am working with schneider somachine software v3.1 and m238 series plc. am using the standard programming cable and the plc is got detected by the PC and it is showing in italics and i cant set active path in somachine software . is it must to use the recommended cable BMXXCAUSBH045 and TCSXCNAMUM3P to do this ?
Programming cable for schneider
- Thread starter JAYyy
- Start date
Similar Topics
Hi
Please I have zeilo smart relay #SR2A201BD but I don't have it's programming cable. Can I use any general usb/rs232 converter? Or need...
Dear all,
I have fx2n plc on my hand but I don't have the programming cable sc-09 and it would not be easy for me to get one. I need the cable...
1203-USB
I can't find it for sale new so I assume it's no longer made? Used, folks want no less than $1k USD for it missing all the cables and in...
Hey Guys
I am trying to figure out the correct cable to use to connect from my laptop to this Panelview using panelbuilder32. I was sure I had...
I need to emergency fabricate a cable to program a Parker 690+ VFD. Part # CM351909 I believe. RJ6 on one end, DB9 on the other. I cannot find the...