learner
Lifetime Supporting Member
Hello,
I'm not sure whether this question is completely related to this forum. I appreciate any help I can get. I am supposed run a series of (Communication) Tests between Contrologix processor and BIFFI Actuator using modbus serial, RTu in this case. I am going to use prosoft module (MCM card). I know how to set up the comms and configure the prosoft module. What I would like to know is:
[/LIST] if someone here has any practical knowledge with this actuator and anything specific that you might like/not like regarding communication with this actuator.
I'm not sure whether this question is completely related to this forum. I appreciate any help I can get. I am supposed run a series of (Communication) Tests between Contrologix processor and BIFFI Actuator using modbus serial, RTu in this case. I am going to use prosoft module (MCM card). I know how to set up the comms and configure the prosoft module. What I would like to know is:
[/LIST] if someone here has any practical knowledge with this actuator and anything specific that you might like/not like regarding communication with this actuator.
- Also any genaral hint regarding testing comms with this type of actuators. i,e Noise issues, length of cable and son on
Anything would help.
Thanks again,
Always a Learner
