ebram
Member
Does anybody out there know of or have used a Wincon 8737 ICP DAS industrial controller? If yes, could you comment on it.
ICP DAS controller
- Thread starter ebram
- Start date
TechEric
Member
The WinCon 8737 is an ISaGRAF licensed controller running WinCE 4.1. It is no longer available.
The replacement is a WinCE 5.0 or 6.0 controller. For CE 5.0, see http://www.icpdas-usa.com/products.php?PID=3379 . For CE 6.0, see http://www.icpdas-usa.com/products.php?PID=3575 . The ISaGRAF project that worked in the WinCon should work in the newer versions with little or no changes.
Development is done in the ISaGRAF Workbench 3.x environment. This has ladder, structured text, flow chart, structured flow chart, and a lower level language.
The replacement is a WinCE 5.0 or 6.0 controller. For CE 5.0, see http://www.icpdas-usa.com/products.php?PID=3379 . For CE 6.0, see http://www.icpdas-usa.com/products.php?PID=3575 . The ISaGRAF project that worked in the WinCon should work in the newer versions with little or no changes.
Development is done in the ISaGRAF Workbench 3.x environment. This has ladder, structured text, flow chart, structured flow chart, and a lower level language.
Last edited:
Similar Topics
Have a fairly simple project wherein id like to monitor half a dozen Rh/temp sensors for dewpoint along with a few temp only sensors.
i studied...
Hi everyone. My customer tell us to check their MDS-A-CR-75 that I have find some manual for a while but not found it. Are there anyone have...
Does anyone happen to have PLC4B and COMU sofware?
ControlLogix 1756-L71 version 20.55. I want to poll this controller from two separate GE iFIX 5.5 SCADAs using the IGS 7.58 driver. Each SCADA...
Hello,
This is my first project with WonderWare Historian so i am a newbie if it comes to this. I am using the Historian to connect to a...
