Hello,
I have a winder with obsolete controls on it, which have failed.
I have had little help from Fanuc on restarting this machine.
I am now investigating what upgrade paths are available to me.
To this end, I was hoping somebody could recommend a reputable integrator or builder that could retrofit new controls to my winder. I hope they would be located in the Southwest, but I am not married to that requirement.
Thanks in Advance.
I have a winder with obsolete controls on it, which have failed.
I have had little help from Fanuc on restarting this machine.
I am now investigating what upgrade paths are available to me.
To this end, I was hoping somebody could recommend a reputable integrator or builder that could retrofit new controls to my winder. I hope they would be located in the Southwest, but I am not married to that requirement.
Thanks in Advance.